Intercall 600 - CMS Lite Call Management Software for Windows

Intercall 600/700 Installation & Operation Guide Issue 4.27 Page 50 of 78
CMS Lite Call Management Software.
The Intercall Call Management Software Lite is a simple way to manage all data from your Intercall 600 or Intercall
700 call system. All system activity is recorded and may be printed at a later stage for use in resident care assessment
reports. The main screen, keeps a track of all system activity as it occurs, with all current calls highlighted, together
with the location of staff. ‘Pop up’ warning screens can be configured to report standard calls, emergency calls or
system faults. In addition, the Intercall Call Management software can be used to connect staff alphanumeric pagers.
These are invaluable for keeping staff in touch with calling residents and specific members of staff can be alerted to
specific events. For instance, the matron can be alerted to emergency calls only while system faults are routed through
to maintenance. There is a ‘Page Staff’ facility, which allows a text message to be sent to any or all staff . The main
screen can be configured for Intercall 600 where the date & time, call type and calling room are shown or Intercall 700
where the calling resident may also be shown. Intercall 700 mode is shown below.
The CMS Lite software requires a L747 Universal Interface to connect to the Intercall system. The software is supplied
with an interface cable fitted with both 9 and 25way connectors. This cable is connected to a serial communication port
on the PC.
The PC Requirements are listed below.
• PC compatible computer with Pentium P4-1000MHz (or equivalent or better)
• CD Rom drive (The software is supplied on CD Rom only)
• Microsoft® Windows 2000/Windows XP (Windows XP Professional recommended)
• 128Mb Ram
• Available 9pin RS232 serial communication port (Only Com1 and Com2 supported in software)
• At least 250Mb free space on hard disk
If the CMS lite software is to be used with the alphanumeric pagers, L747YL three way serial lead is required which
connects to the PC, L747 and Scope pager transmitter.
Password Access and Installation Details.
A password is required to enter the ‘Setup’ screen or exit the software. Installation details and factory default
passwords are contained within the readme.txt file supplied on the CD Rom
.
Intercall 600
9
Intercall 700
9