Interlogix NX-595E - Service Provider Phone Number

22 NX-595E Installation Manual
0.2 Time & Date
0.3 Partition Entry Time
0.4 Partition Exit Time


0.5
Phone number configuration
0.5.1
Alarm phone number One
0.5.2
Alarm phone number Two
0.5.3
Alarm phone number Three
0.5.4
Divert phone number One
0.5.5
Divert phone number Two
0.5.6
Divert phone number Three


0.5.0 Service provider phone number
0.6 Voice message recording
0.0 Panel and device configuration
Service provider phone number
Menu 0.5.0. This is the phone number you wish your clients to call for servicing;
this number will be announced via your NX-181xx Voice keypads, each arming
and disarming cycle whilst a system fault is present.
How to: Enter Service provider phone number
Step Example Enter service provider phone numbers
1.
[PIN]

Call the NX-595E via an offsite touch-tone phone to
begin the session.
2.
Press [0] for system configuration menu
Press [5] for phone number configuration
Press [0] for service provider phone number
3.
Select a new alarm / divert phone number, followed by #
4.
1
s
t
star. Move back to step 3, phone number selection
2
nd
star, moves back to system configuration menu
3
rd
star, moves back to main menu
# Disconnects session
0
-
System Configuration

0.1 User Configuration

0.2 Time & Date

0.3 Partition Entry Time

0.4 Partition Exit Time

0.5
Phone number configuration
0.6 Voice message recording
 0.0 Panel and device configuration