NX-595E Installation Manual 31
Outputs
The two onboard relays are defaulted as Door 1 and Door 2 control and are
controlled when an intercom session is established between an outdoor station
and NX-181xx Voice keypads.
Relay trigger events are selectable and can be chosen from a drop down
“Activation events” list from within the web interface. Events can only be
selected from within the NX-595E web interface.
Note: From the activation event drop down list “Output 1 Trigger” and ”Output 2
Trigger” are fixed X10 module commands 0 and 1. This allows you to send an
X10 module command 0 or 1 remotely by using Menu 4-Output Control on the
NX-595E.
Drop down Event X10 Module Number
Output 1 trigger 0
Output 2 trigger 1
To Next Page
Loading...
