Interlogix NX-595E - Page 40

40 NX-595E Installation Manual
Location 5 - Alarm Phone Number One (1)
The first voice message phone number is programmed in Location 5
15 = Pulse dialing – in the segment where pulse dialing should begin
14 = Indicates the end of the phone number
13 = Creates a four second delay
12 = #
11 =
*
Segments 1-20 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
Location 6 - Alarm Phone Number Two (2)
The second voice message phone number is programmed in Location 5
15 = Pulse dialing – in the segment where pulse dialing should begin
14 = Indicates the end of the phone number
13 = Creates a four second delay
12 = #
11 =
*
Segments 1-20 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
Location 7 - Alarm Phone Number Three (3)
The third voice message phone number is programmed in Location 5
15 = Pulse dialing – in the segment where pulse dialing should begin
14 = Indicates the end of the phone number
13 = Creates a four second delay
12 = #
11 =
*
Segments 1-20 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14
Note: If multiple phone numbers are entered, the NX-595E will call each number in turn until it is
answered or the designated number of dial attempts set in Location 3 has been reached. The NX-
595E will first call phone number 1, wait 25 seconds for a PIN to be entered, if not entered it will
hang up for 6 seconds, then call phone number 2 and repeats this process for phone number 3.
Location 8 - Reserved
Location 9 - Reserved
Location 10 - Reserved
Location 11 - Reserved
Location 12 - Reserved