EN
Programm
OK
Neu
OK
Mit Datum?
Ja / Nein
OK
Menu
Program
New
With Date?
Yes/No
FKT wählen
Zyklus
OK
Zeit
09:00
... Minute
OK
Dauer EIN
00:10:00
. Minuten ..
OK
Dauer AUS
00:30:00
. Minuten ..
Select FNC
Cycle
Time
09:00
... Minutes
Period ON
00:10:00
. Minutes ..
Period OFF
00:30:00
. Minutes ..
Tage
12345--
Mo–Fr
OK
Kanäle
(1)
1–
CH1
OK
Weitere Schaltzeit?
Ja/Nein
OK
Priorität
(2)
Hoch
Days
12345--
Mo-Fr
Channels
(1)
1–
CH1
Add Time?
Yes/No
Priority
(2)
High
1. Press the
Menu
button:
2. Select
Program
and conrm
with
OK.
For clarication of the following action steps, see ow chart.
3. Select
New
and conrm with
OK
.
4. In step
With date?
determine whether the device should be activated on a certain date and - if
yes - conrm with
OK
(also refer to Seite 52).
5. Select
Cycle
and conrm with
OK
.
6. Enter hour and minute of the start time (+/-) and conrm each with
OK
.
7. Enter period ON (+/-) and conrm each with
OK.
8. Enter period OFF (+/-) and conrm each with
OK.
9. Select weekdays (+/-) on which the cycle should be started and conrm with
OK
.
NOTE: The weekdays 1-5, 6-7 and 1-7 are preset. Individual weekdays can be set (+/-) under
"Select days".
10. Select channel
(1)
(+/-) for which the cycle should be set, and conrm with
OK
.
NOTE: The plus sign stands for active, the minus sign for an inactive channel.
11. And choose possible
Priority
(2)
.
Program the command
OFF
in Menu
FKT
end the cycle switching command.
(1)
The channel selection is only available with 2-channel timers
(2)
The choice of priority is only possible in advanced mode; refer to „Dening prioritisation of programs“
auf Seite 61.
59
To Next Page
Loading...
Need help?
General
