EN
D
Cycle programming
(1) Start time
(2) Duration ON
(3) Duration OFF
The cycle programming is only possible in advanced mode;
refer to „Mode“ auf Seite 72.
A cycle switching command consists of:
• Start time
• Period ON = Switching ON
• Period OFF = Switching OFF
Example:
Channel 1 is switched on from Monday 9:00 to Friday 19:00 every 30 minutes for 10 minutes.
Start time 9:00
Duration ON 10 minutes
Duration OFF 30 minutes
Separate OFF command 19:00
To end the cycle, an independent command of
OFF
must be set.
A nesting of cycle programs is not allowed
58
To Next Page
Loading...
