Intermatic MultiWave

15 Mounting
Mounting the PE653 Receiver on the Load Center
Follow this procedure to mount the PE653 Receiver on the load center.
1. Looking at the load center mounted on the supporting structure/surface, remove the
knockout located on the top right side. If no knockout is present, there should be a dimple
to use as a guide for drilling a 1-3/8" hole with a hole saw or punch. NOTE: DO NOT remove
the left-side knockout, as this is used to gain access to the low voltage raceway.
2. Remove the PE653 Receiver from the top of its small beige steel standard enclosure by
removing the plastic hub nut. Discard the standard enclosure and retain the plastic hub nut.
3. Use the plastic hub nut to mount the receiver to the top right of the load center. NOTE:
Gasket is required for rain tight connection for outdoor enclosures.
Figure 2-2. Mounting PE653 on load center.
Gasket