31Filter Pump Installations
External Variable Speed Pump Hookup
Other variable speed pumps compatible with the MultiWave receiver include Jandy
®
, Hayward
®
,
Marathon
®
, Century
®
and Speck
®
.
NOTE: A CAT5-568B network cable is required to route between the P5043ME Expansion
Module and the variable speed pump.
1. Insert the network cable into the Motor Control Input as shown in Figure 5-4.
2. Cut off the second RJ45 connector from the other end of the cable and strip each connector
wire.
3. Refer to the applicable gure for the variable speed pump manufacturer (Figure 4-12 to
Figure 4-15) to connect the wires to the expansion module.
To Next Page
Loading...
