Intermatic MultiWave

MultiWave Pool & Spa Control System
Worksheet for Programming
SYSTEM COMPONENTS:
¸ Freeze (Air Temperature) Sensor
¸ Water Temperature Sensor
¸ Solar (Air Temperature) Sensor
¸ Antenna Extender
¸ Pentair Variable Speed Pump (VSP)
¸ AutoPilot Salt Chlorine Generator (SCG)
¸ FREEZE OPTION IS DESIRED.
¸ OTHER Z-WAVE DEVICES ARE USED.
¸ P5043ME Expansion Module
¸ Water Feature (Act 3)
¸ Heater #1
¸ Heater #2
¸ Solar Temperature System (Act 4)
¸ Remote Switch
¸ Other Variable Speed Pump (VSP)
Act 2
Act 1
Act 3
Act 4
Power In
240 VAC
Heater #1
Heater #2
Remote
Switch
123 4 5 6 7 8 9
1 2 3 4 5
Water
Temperature
Sensor
Circuit
1
Circuit
2
Circuit
3
Circuit
4
Circuit
5
Power In
120or240 VAC
L1 120
VACWire
L2
120V
240V
Solar/Air
Temperature
Sensor
Freeze/Air
Temperature
Sensor
Antenna
Extender
(CAT5)
Pentair VSP and/or SCG
OR Expansion Module
NOTE: For circuit options, see Chapters 4 through 6.
Put a dash in the circuits that are not used.
Circuit 1 _______________________________________
Circuit 2 _______________________________________
Circuit 3 _______________________________________
Circuit 4 _______________________________________
Circuit 5 _______________________________________
NOTE: If this system does not include P5043ME,
draw an “X” through the entire second column.
PE653 Receiver P5043ME Expansion Module
Other VSP
(CAT5)