Chapter 5 — Network Support
150 CN3 Mobile Computer User’s Manual
iConnect
With iConnect, you can manage these features of your CN:
• FTP server
• Network interfaces
FTP Server
iConnect allows you to:
• enable or disable the FTP server.
• manage the state of the FTP server based on the registry key settings.
iConnect manages the state of the FTP server when iConnect first starts
and when a network change occurs though iConnect.
The easiest way to manage the FTP server is to enable the FTP menu
within iConnect.
To enable the FTP menu
• Create this DWORD registry key and set it to a value of 1:
HKEY_CURRENT_USER\Software\iConnect2\IConnect\Settings\ShowFTPMenu
The iFTP menu is available the next time you start iConnect.
To manage the state of the FTP server
• Modify these existing registry keys:
HKEY_CURRENT_USER\Software\iConnect2\IConnect\Settings\FtpAutoStart
HKEY_CURRENT_USER\Software\iConnect2\IConnect\Settings\FtpHeartbeat
where 1 = enable and 0 = disable.
Network Interfaces
The default network adapter or radio is dependent on what radios are
installed in your CN3. With the iConnect menu, using the Enable feature,
you can specify “Wireless” or “No Networking” to load onto your CN3
when a cold-boot is performed.
If you had specified a network prior to when a warm-boot is performed on
the CN3, the iConnect application restores your network interfaces to what
they were before the warm-boot was performed.
See the Developer’s Support area of the Intermec web site for the latest
information on network adapters for your CN3.
To Next Page
Loading...
