Chapter 1 — Using the Computer
CN3 Mobile Computer User’s Manual 29
To press the reset button
1 Press the power button to suspend the CN3.
2 Remove the battery pack from the back of the CN3.
3 With a stylus, press the reset button in the battery cavity in the back.
4 Press and hold the power button as you put the battery back in the CN3.
Clean Boot Process
If performing either reset method fails to restore system operation, it may
be necessary to perform a clean boot. This is a boot method which formats
the object store to clean data and registry information from the CN3
system and restores them to their factory default state.
To perform a clean boot
1 Press the power button to suspend the CN3.
2 Remove the battery pack from the back of the CN3.
3 With a stylus, press the reset button in the battery cavity in the back.
4 Press and hold the power button as you put the battery back in the CN3.
5 Continue to hold the power button until a Warning message appears on
the display, release the power button, then read the message.
6 To continue with the clean boot, press either right side button.
To cancel the clean boot, press either left side button.
Do not use force or a sharp object when pressing the reset button. You
may damage the reset button.
Note: This will erase the memory in the CN3, including all applications
and data files found in the object store (user store). See “Packaging
Applications for the Computer” on page 80 for more information.
To Next Page
Loading...
