Intermec CN3 - Setting Vibrate Mode

Chapter 1 — Using the Computer
CN3 Mobile Computer User’s Manual 25
Setting Vibrate Mode
To set your CN3 to vibrate
•Tap the Volume icon at the top of the screen, then tap Vibrate. If your
CN3 has a built-in phone, this sets both the volume and the phone to
vibrate. Note the icon change.
To set your CN3 to vibrate using the Intermec Settings applet
1 Tap Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Device Settings > Beeper > Vibrate, then tap
Vibrate.
3 To disable the vibrate, tap the Beeper option.