Chapter 1 — Using the Computer
22 CN3 Mobile Computer User’s Manual
Adjusting the Volume
You can control the volume by pressing the two scan buttons on the right
side of the CN3 as shown above, using the Volume drop-down in the
toolbar, or the Intermec Settings applet.
In either situation, tap Off to disable the volume.
To adjust the volume for the speaker
To use the Intermec Settings applet to adjust the volume
1 Tap the Volume icon at the top of the screen.
2 Tap On, then move the system volume slider to the desired volume level.
Up is louder, down is quieter.
If your CN3 comes with a phone, be sure to use the left slider bar for the
volume for the rear speaker, and to use the right slider bar for the phone
(front speaker).
1 Tap Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Device Settings > Beeper > Volume.
3 Tap any of the options other than “Off” to enable and adjust.
Phone slider barVolume slider bar
To Next Page
Loading...
