Chapter 5 — Network Support
CN3 Mobile Computer User’s Manual 151
To access the iConnect menu
• Select Dismiss from the iConnect menu to end the session without
exiting the application.
• Select Exit iConnect to exit the application.
To access the iConnect application after you have exited it
• Perform a warm-boot on the CN3. The iConnect icon then reappears
above the command bar.
No Networking
To disable the networking interface
• Select Enable > No Networking from the iConnect menu.
The Wireless radio tower icon is replaced with one that shows an “X,” a
check mark appears next to the “No Networking” option in the menu, and
the iConnect application disables all other networking interfaces.
Wireless Communications
To enable wireless communications on the CN3
• Select Enable > Wireless from the iConnect menu.
The Wireless icon (shaped like a radio tower) appears in the toolbar, a
check mark appears next to the “Wireless” option in the menu, and wireless
communications is enabled.
To configure wireless communications on the CN3
• Select Tools > Wireless Settings from the iConnect menu to access the
Profile Wizard for the 802.11b/g radio module.
To configure wireless 802.11b/g communications using the Profile Wizard
•Tap the iConnect icon (shown to the left) above your command bar.
•Tap Start > Settings > the System tab > the Wireless Network icon to
access the Profile Wizard. Go to “Configuring Microsoft Security” on
page 178 for information.
To Next Page
Loading...
