Chapter 7 — Configuring the Computer
CS40 Mobile Computer User’s Manual 79
e Press Enter.
9 For Network Key Setting, choose Automatic.
10 Save your settings.
Configuring Static WEP Security With Microsoft
After you configure the communications and radio parameters on
your mobile computer and select Microsoft as your security choice,
you can configure static WEP security with Microsoft. Intermec
recommends that you use WPA2-PSK instead of WEP if possible.
To configure static WEP security with Microsoft:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Microsoft Security.
3 For Network Authentication, choose Open.
4 For Data Encryption, choose WEP.
5 For Network Key Setting, choose Enter Key and Index.
6 For Network Key Value, enter an ASCII key or a hex key that is
either 5 bytes or 13 bytes long depending on the capability of the
radio.
Set a 5-byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13 hex
pairs.
7 For Network Key Index, select the key you want to use for data
transmission. Save your settings.
8 Save your settings.
Using Open (No Security) Associations With Microsoft
You can configure your mobile computer for no security with
Microsoft.
To configure Open security with Microsoft:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Microsoft Security.
3 For Network Authentication, choose Open.
To Next Page
Loading...
Need help?
General
