Intermec EasyCoder F4 - Page 15

Intermec EasyCoder F4 – Installation & Operation Ed. 314
Chapter 2 Printing a Label
Using Intermec
Fingerprint, cont.
Changing a Program Line
If you want to change a program line, simply rewrite the line using
the same line number. For example, move the text to the right by
rewriting line 80 with a different X-coordinate:
80 PRPOS 75,220 ↵
RUN ↵
Saving the Program
If you want to save your fi rst attempt, issue the following com-
mand.
SAVE "LABEL1" ↵
Your program will be saved in the printer’s permanent memory
under the name:
LABEL1.PRG
Loading the Program
If you want to use this label later, for example after having created
more programs, type:
LOAD "LABEL1.PRG" ↵
RUN ↵
A new copy of the label will be printed.
The Intermec Fingerprint offers many more advanced functions
that allow you to create sophisticated application programs or
to emulate other printer protocols. For more information on the
subject of programming, please refer to the documentation of the
Intermec Fingerprint programming language.