Intermec EasyCoder F4 User Manual

Intermec EasyCoder F4 – Installation & Operation Ed. 360
Chapter 8
The method of entering the Setup Mode depends on which startup
fi les are stored in the printer’s memory, a subject that was more
thoroughly discussed in Chapter 4, “Starting Up”.
EasyCoder F4 with Intermec Shell
• Switch on the power.
• When the display shows the message “Enter=Shell; x sec...”,
press <Enter>.
• Press <Setup> (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing <Setup>.
EasyCoder F4 with a custom-made application program
• Normally, there is no need to enter the Setup Mode for custom-
made application programs. Necessary provisions for changing
the setup, manually or automatically, should be provided by
the program.
Entering
Setup Mode
at Installation
Setup Mode

Intermec EasyCoder F4 Specifications

General

Brand	Intermec
Model	EasyCoder F4
Category	Printer Accessories
Language	English