Intermec EasyCoder F4 – Installation & Operation Ed. 3 57
Chapter 7 Setting Up the Printer
Setup Parameters, cont.
Print Defi nes, cont.
Test Label #1
Test Label #2
Test Label #3 Test Label #4
Test Label #5
681 ohms/8 dots
UART1 9600-8-N-1
RTS/CTS DISABLE
ENQ/ACK DISABLE
XON/XOFF
DATA TO HOST DISABLE
DATA FROM HOST DISABLE
NEW LINE CR/LF
REC BUF 300
TRANS BUF 300
PRINT CONFIG
STARTADJ 0
STOPADJ 0
XSTART 24
WIDTH 808
LENGTH 1200
MEDIA TYPE LABEL (w GAPS)
PAPER TYPE TRANSFER
LABEL CONSTANT 85
LABEL FACTOR 40
RIBBON CONSTANT 90
RIBBON FACTOR 25
LABEL OFFSET 0
LOW DIAMETER 36
CONTRAST +0%
TESTFEED 12 3
HEAD RESIST 681
PRINT SPEED 100
Odometer [km] 0
Model F4
Hardware version 3.0
Ram 4096 ( k)
Flash 0+2048 (k)
External 0 (k)
c: 1819504 bytes free
FIRMWARE
Fingerprint 7.40
MCS1147 27-Sep-00 15:43:38 m3k
slav0782 27-MAY-97 17:09:25 [0]
No keyboard slave [1]
To Next Page
Loading...
