Intermec EasyLAN Wireless—Interface Kit Installation Instructions 21
Chapter 3—Setup in Fingerprint
Setting Up Network Parameters
In this document, the use of setup strings or setup fi les are described.
Network parameters could also be set via the printer’s built-in keyboard
as described in the User’s Guide.
New Line
Set the New Line parameter using a setup string or setup fi le:
SETUP"NET-COM,NET1,NEW LINE,CR/LF"
SETUP"NET-COM,NET1,NEW LINE,LF"
SETUP"NET-COM,NET1,NEW LINE,CR"
Default is CR/LF.
IP Selection Method
There are four methods for setting the IP address. DHCP, BOOTP,
and DHCP+BOOTP let the server assign a temporary IP address to
the printer. Which method to choose depends on the server. DHCP,
BOOTP, and DHCP+BOOTP also sets the netmask, default router,
and name server automatically. If the server neither supports DHCP nor
BOOTP, or if you want to set a permanent IP address manually, use the
MANUAL option. In this case, you will also have to set the netmask,
default router, and name server manually via the printer’s keyboard.
Always consult the network administrator before assigning
a permanent IP address to avoid having more than one
device with the same IP address in the network.
Set the IP selection method parameter using a setup string or setup fi le
(by default only allowed for
admin
1
):
SETUP"NETWORK,IP SELECTION,DHCP+BOOTP" (default)
SETUP"NETWORK,IP SELECTION,MANUAL"
SETUP"NETWORK,IP SELECTION,DHCP"
SETUP"NETWORK,IP SELECTION,BOOTP"
1
/. However, anybody can change the IP selection method from the
printer‘s keyboard using the Setup Mode.
To Next Page
Loading...
