EasyLAN Wireless Interface Kit Installation Instructions 5
Chapter 1 — Introduction
For Users Outside of the United States and Canada
e Intermec product you purchased contains a Mode 802MIG2 trans-
ceiver module. is module transmits and receives data using a 2.4 GHz
Direct Sequence Spread Spectrum system.
Please check the Intermec web site for additional documentation at
www.intermec.com.
Hereby, Intermec Technologies Corporation declares that this Model
802MIG2 is in compliance with the essential requirements and other
relevant provisions of R&TTE Directive (1995/5/EC). is product has
been assessed to the following standards:
• ETSI EN 300 328-2 v1.2.1 (2001-12)
• ETSI EN 301 489-17 v1.1.1 (2001-09)
• EN 60950:1992 (incl. Amdt. 1-4,11)
e original Declaration of Conformity is available on the Intermec
Technologies Corporation web site at www.intermec.com.
is product transmits electromagnetic waves at 2.4 GHz frequency
range. It has been tested and found compliant with U.S. (OET Guide
65) and Canadian (RSS 102) RF exposure regulations. ere are no
regulations covering this product type in the European Union at this
time.
e transmitter module’s output power is 11.6 mW. e product using
this module are intended for business and industrial environments. ey
should not be used in residential environments and by children.
is product is marked with this logo and uses
radio frequency bands that are not harmonized
throughout the European Union.
To Next Page
Loading...
Need help?
General
