Intermec PX4i

Chapter 3 — Configuring the Printer
86 PX4i and PX6i High Performance Printer User’s Manual
Use the following table to understand the general network settings.
Understanding the General Network Settings
Setting Description
Printer Name The network identification name (WINS name) of the
printer. The default name is INTERMEC followed by
the last six positions of the MAC address.
System Location (Optional) The printer location.
System Contact (Optional) The printer administrator.
Set Password You must check this box if you want to change the
admin password.
Old Admin
Password
You need to enter the old password before you can
change the password.
New Admin
Password
The new password you want to use.
Restrictions Sets restrictions on who is allowed to upgrade the
printer firmware or view and change network settings.
You cannot remove “admin” from the list of authorized
users.
Users allowed to update: Defines who may perform a
firmware upgrade using FTP, PrintSet, or IFAB. This
setting does not affect upgrading from a Compact
Flash card.
Users allowed to read/write protected LAN1
settings: (Fingerprint only) Defines who may read/
write settings in the LAN1 section.
Users allowed to change network settings:
(Fingerprint only) Defines who may change the
network node in the setup. This setting is not
supported if you are setting up the printer from its
internal keyboard.
Users allowed to change wireless settings: Defines
who may change WLAN or 802.1x settings.