Intermec PX4i

Chapter 1 — Using the Printer
52 PX4i and PX6i High Performance Printer User’s Manual
13 Set the Paper Type to Thermal Transfer Ribbon (TTR).
a On your printer’s keypad, press T to enter the Setup menu.
b If you are using Fingerprint, go to Media > Paper Type >
Transfer.
If you are using IPL, go to Media > Paper Type > TTR.
c Press E.
d Press T to exit the Setup menu.
Printing a Test Label
You can print a test label (perform a testprint) to:
• make sure that your printer is working properly.
• get your printer’s setup, hardware, and network information.
• get RFID tag information.
• check print quality and determine which adjustments to make.
To perform a testprint
1 Press T to enter the Setup menu, and use the keypad to go to the
TESTPRINT menu:
• If you are running Fingerprint, go to SETUP > PRINT DEFS >
TESTPRINT.
• If you are running IPL, go to SETUP > TEST/SERVICE >
TESTPRINT > CONFIG.
2 Select a testprint to perform. For more information, see the next
tables.
Fingerprint Testprint Options
Testprint Description
Diamonds Prints a diamond pattern.
Chess Prints a chess board pattern.
Bar Codes #1 Prints a horizontal set of bar codes.
Bar Codes #2 Prints a vertical set of bar codes.