Chapter 1 — Using the Printer
PX4i and PX6i High Performance Printer User’s Manual 25
17 Close the front door and media cover.
18 Press F to advance the media and adjust the media feed.
Loading Media for Cut-Off Printing
You can install the automatic paper cutter option to cut off the
media. Cut-off printing can be used for non-adhesive continuous
stock and self-adhesive labels with liner (cut only liner between
labels). The cutter option:
• is designed for paper-based media with a thickness between
60 and 175 μm, roughly corresponding to a paper weight of
60 to 175 grams/m2 (basis weight 40 to 120 lb).
• cuts through the media approximately 37 mm (1.5 in) in front of
the printer’s dot line. Make sure to properly adjust the media feed.
For help, see “Configuring Your Printer” on page 76.
• should not be used to cut through labels, because the adhesive
sticks to the shears, which can damage the cutter. If you do cut
through adhesive labels, tilt the cutter down and clean it with
isopropyl alcohol.
• must be enabled in Setup mode. For help, see “Configuring Your
Printer From the Screen” on page 76.
• is held by a latch inside the media compartment and can be tilted
forward to facilitate loading media.
To Next Page
Loading...
