Intermec PX4i

Chapter 3 — Configuring the Printer
90 PX4i and PX6i High Performance Printer User’s Manual
Use the following table to understand SNMP settings.
Understanding the SNMP Settings
Setting Description
Read Community Community with rights to read the SNMP MIBs.
Read/Write
Community
Community with rights to read and write SNMP MIBs.
Username Username when using SNMPv3. The default value is
“initial”.
Authentication Key The authentication key for SNMPv3. The default value
is “auth_key”.
Encryption Key The privacy key for SNMPv3. The default value is
“priv_key”.
System Name Administrative name for the SNMP node.
Authentication
Failure Trap
Defines if a trap is sent when an unauthorized SNMP
request tries to access the printer. Choose Enable to
send the trap.
Trap Address
Settings
Click Add to specify these trap address settings:
• Trap Address: IP address of the receiver of SNMP
traps. You can specify up to four trap addresses.
• Trap Port: The port where SNMP traps are sent.
The default port if 162.
• Trap Community: Defines the community to
which SNMP traps will be sent.
• Friendly Name: A user-defined text string that
identifies the trap.
• Trap Enable Status: Defines whether the specified
trap is enabled.