Intermec PX4i

Appendix A — Specifications
148 PX4i and PX6i High Performance Printer User’s Manual
Liner (b)
The backing paper must not extend more than a total of 1.6 mm
(0.06 in) outside the labels and should protrude equally on both side.
Recommended minimum transparency: 40% (DIN 53147).
The Label Stop Sensor (LSS) must be able to detect the extreme front
edges of the labels.
Media Width Excluding Liner (c)
Printer Measurement Value
PX4i Maximum 118.4 mm (4.66 in)
Minimum 23.8 mm (0.94 in)
PX6i Maximum 168.4 mm (6.63 in)
Minimum 74.4 mm (2.93 in)
Label Length (d)
Measurement Value
Minimum without LTS 8 mm (0.32 in)
Minimum with LTS 12 mm (0.47 in)
Maximum 6,143 mm (241 in) Depends on SDRAM size.
Note: Under ideal circumstances, a minimum label length of 4 mm
(0.16 in) could be used. It requires the sum of the label length (d) and
the label gap (e) to be larger than 7 mm (0.28 in), that batch printing is
used, and that no pull back of the media is performed. Intermec does
not guarantee that such short labels will work, but it is up to users to
test this in their unique application.
Label Gap (e)
Measurement Value
Maximum 25.0 mm (0.98 in)
Recommended 3.0 mm (0.12 in)
Minimum 1.2 mm (0.05 in)