Intermec PX4i

Appendix A — Specifications
150 PX4i and PX6i High Performance Printer User’s Manual
Tickets With Gaps (Gap Stock)
LSS Detection Position (c)
This position is variable. For help, see “Adjusting the Label Stop
Sensor” on page 121.
Detection Slit Length (d)
The length of the detection slit (excluding corner radii) must be a
minimum of 2.5 mm (0.10 in) on either side of the LSS detection
position (c).
Media Width (a)
Printer Measurement Value
PX4i Maximum 120 mm (4.72 in)
Minimum 25.0 mm (1.00 in)
PX6i Maximum 170 mm (6.69 in)
Minimum 76.0 mm (3.00 in)
Copy Length (b)
Measurement Value
Minimum without LTS 8 mm (0.32 in)
Minimum with LTS 12 mm (0.47 in)
Maximum 6,143 mm (241 in) Depends on SDRAM size.
Note: Under ideal circumstances, a minimum ticket length of 4 mm
(0.16 in) could be used. It requires the sum of the copy length (b) and
the detection slit height (e) to be larger than 7 mm (0.28 in), that batch
printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short tickets will work, but it is
up to users to test this in their unique application.
Detection Slit Height (e)
Measurement Value
Maximum 25.0 mm (0.98 in)
Recommended 1.6 mm (0.06 in)
Minimum 1.2 mm (0.05 in)