Chapter 2 — Connecting the Printer
PX4i and PX6i High Performance Printer User’s Manual 61
To connect your printer to your Ethernet network
1 Make sure that Ethernet is selected as your Network Type.
a On the keypad, press T to enter the Setup menu.
b Go to SETUP > NETWORK > NETWORK TYPE >
ETHERNET.
c Press T again to exit the Setup menu.
2 Connect the cable from your Ethernet network to the Ethernet
port on your printer’s back plate.
3 Turn your printer off and then on.
4 Enter Information mode by pressing the I button. The printer
displays interface information in five-second intervals. Note the IP
address displayed under I/O net1.
5 On your PC, start your web browser.
6 Enter the IP address of your printer in the address field and press
Enter. Your printer home page appears.
7 When you are prompted, enter your login and password. The
default values are: login = admin, password = pass.
For help using the printer web page to configure your printer, see
“Configuring Your Printer From the Printer Home Page” on
page 78.
To Next Page
Loading...
