Chapter 2 — Scanning with the SR31T Tethered Scanner
SR31T Tethered Scanner User’s Guide 15
By default, when the SR31T successfully reads a bar code, it beeps
once, the status light briefly turns green, and the scanner beam
turns off. If Vibrate Alert is enabled, the scanner briefly vibrates.
3 Release the trigger.
Scanning Bar Codes: The aiming and scanner beams that you see depend on
which SR31T model you are using.
To scan with an SR31T 2D imager model (2D or HP)
1 Point the scanner at the bar code and hold the SR31T steady a few
inches from the label.
2 Pull the trigger and use the laser framing or aiming beam to
position the imager over the bar code or area to capture.
Use this test bar code:
Code 39 Test Bar Code
*123456*
*123456*
To Next Page
Loading...
