Interroll RollerDrive EC200 - Speed settings

12
Version 1.0 (11/2007) en
Original language
Product information
RollerDrive EC200
Speed settings
If you do not use the recommended DriveControl (see "DriveControls for the
RollerDrive EC200", page 10), you may change the speed of the RollerDrive
EC200 by altering the voltage on pin 5 of the motor plug.
Input voltage of Pin 5 at motor plug is not polarity-
proof
Damage to the RollerDrive
¾ Ensure the correct polarity.
$QDORJYROWDJHVHWWLQJRQSLQRIPRWRUSOXJ>9'&@

6SHHG3HUFHQWDJH>@










Hint
In the hatched area the RollerDrive does not run within the specified tolerance of
±5%.
Rotary switch
speed setting at
DriveControl
Voltage setting
on pin 5
[VDC]
Speed of transport [m/s (ft/min)] ± 5 %
Gear ratio
12:1
Gear ratio
16:1
Gear ratio
36:1
Gear ratio
48:1
Gear ratio
64:1
0/8
5 to 24
0.98 (192.7) 0.74 (145.6) 0.33 (64.2) 0.25 (49.2) 0.18 (36.1)
1/9 0.98 (192.7) 0.74 (145.6) 0.33 (64.2) 0.25 (49.2) 0.18 (36.1)
2/A 4 0.75 (147.2) 0.56 (110.4) 0.25 (49.1) 0.19 (36.8) 0.14 (27.6)
3/B 3.75 0.56 (110.4) 0.42 (82.8) 0.19 (36.8) 0.14 (27.6) 0.11 (20.7)
4/C 3.30 0.41 (80.1) 0.31 (60.1) 0.14 (26.7) 0.10 (20.0) 0.08 (15.0)
5/D 2.93 0.30 (58.5) 0.22 (43.8) 0.10 (19.5) 0.07 (14.6) 0.06 (11.0)
6/E 2.68 0.21 (41.1) 0.16 (30.9) 0.07 (13.7) 0.05 (10.3) 0.04 (7.7)
7/F 2.44 0.14 (28.1) 0.11 (21.1) 0.05 (9.4) 0.04 (7.0) 0.03 (5.3)