25
Version 1.0 (11/2007) en
Original language
RollerDrive EC200
Maintenance and cleaning
Maintenance and cleaning
Warning notices concerning maintenance and cleaning
Maintenance
Checking the RollerDrive If the RollerDrive is not secured as specified in the installation instructions (see
"Assembly", page 18), it may rotate in the hole in the conveyor frame. This will
result in the roller leads becoming twisted and eventually severed.
¾ Monthly check the RollerDrive for visible damage.
¾ Annually ensure that the roller shaft is secured properly in the conveyor
frame.
Replacing a RollerDrive If a RollerDrive is damaged or broken down, it has to be replaced.
¾ Install a new RollerDrive (see "Abandonment", page 27 and see "Inserting the
RollerDrive EC200 in the conveyor frame", page 20).
Cleaning
Increased surface friction reduces the roller speed since more power is used to
overcome the resistance. Therefore, in a dirty environment, periodic cleaning will
ensure good contact with the goods and reduce friction.
¾ Remove foreign material from the roller with standard cleaners.
¾ Do not use sharp-edged tools to clean the roller.
Risk of injury due to improper handling or accidental
motor starts
¾ Maintenance work and cleaning may only be executed
by qualified and authorized persons.
¾ Only perform maintenance work after switching off the
power. Ensure that the RollerDrive cannot be turned on
accidentally.
¾ Set up signs indicating maintenance work.
CAUTION
To Next Page
Loading...
Need help?
General
