27
Version 1.0 (11/2007) en
Original language
RollerDrive EC200
Abandonment and disposal
Abandonment and disposal
Abandonment
¾ Disconnect the motor cable from the control.
¾ Unscrew the outer nut at the threaded motor shaft.
¾ If the RollerDrive has a spring-loaded idler shaft, push the idler shaft inwards.
¾ If the RollerDrive has a FTM8 idler shaft, unscrew the bolt at the idler shaft.
¾ Extract the RollerDrive from the conveyor frame.
Disposal
The operator is responsible for the proper disposal of the RollerDrive. In doing
so, industry-specific and local provisions must be observed for the disposal of
the RollerDrive and its packaging.
Risk of injury due to improper handling
¾ Abandonment may only be executed by qualified and
authorized persons.
¾ Only abandon the RollerDrive after switching off the
power. Ensure that the RollerDrive cannot be turned on
accidentally.
CAUTION
To Next Page
Loading...
