Interroll RollerDrive EC200 - Conical RollerDrives

16
Version 1.0 (11/2007) en
Original language
Product information
RollerDrive EC200
Conical RollerDrives
Conical RollerDrives are only available in three versions:
• Without roll-to-roll transmission (no grooves)
• With grooved tubes [RL
EU
= B/F - 11 mm (0.44 in) / RL
US
= B/F - 3 mm
(0.12 in)]
• With O-ring hub [RL
EU
= B/F - 37 mm (1.46 in) / RL
US
= B/F - 3 mm (0.12 in)]
B/F: Width between the conveyor frames
Due to the conical sleeves they are only available in certain standard lengths.
For conical RollerDrives there must be a 1.8° angle compensation on the motor
end to avoid bending forces on the RollerDrive.
Hint
For details contact Interroll, see the catalogs or refer to publications at
www.interroll.com.