Invacare Solara 3G - Installing the Anti-Tippers

4 OPERATION
Invacare® Solara®3G/Spree 3G Wheelchair 50 Part No 1154295
4.11 Installing the Anti-Tippers
1. Remove the anti-tippers from the accessory carton.
2. Press the release buttons in and install the anti-tippers with the
wheels facing down until the locking buttons lock in place
(FIGURE15).
3. Adjust the anti-tippers. Refer to Adjusting the Anti-Tippers
on
page 70.
FIGURE15 Installing the Anti-Tippers

WARNING
Anti-tippers MUST be fully engaged and release
buttons fully protruding out of the adjustment holes.
Ensure both anti-tippers are adjusted to the same
mounting hole.
The manual wheelchair is intended for indoor and
outdoor use on firm surfaces. When outdoors on
wet, soft ground or on gravel surfaces, anti-tippers
may not provide the same level of protection
against tip over. DO NOT operate on soft
surfaces such as sand, grass or gravel.

A 1
1
/
2
to 2
1
/
4
inch clearance between the bottom
of the anti-tipper wheels and the floor MUST be
maintained at all times.
Release Button
Anti-tipper
Locking
Button
Wheelchair Frame
Release Button
Anti-tipper
(Wheeled Portion)