Invacare Solara 3G - Adjusting T-Arm Sockets

11 ARMS
Part No 1154295 93 Invacare® Solara®3G/Spree 3G Wheelchair
11.3 Adjusting T-Arm Sockets.
1. Remove the rear wheels from the wheelchair, if necessary. Refer to
Installing/Removing Rear Wheels on page 116.
2. Loosen, but DO NOT remove the four hex screws and washers
that secure T-Arm socket to T-Arm clamp..
3. Slide the T-Arm into the T-Arm socket until the locking lever is in
the slot in the T-Arm socket and an audible "click" is heard.
4. Squeeze the T-Arm socket and the T-Arm clamp together until the
socket is flush with the T-Arm.
5. While holding the T-Arm socket and the T-Arm clamp together,
tighten the four hex screws and washers. Tighten securely.
6. Press IN on the locking lever and lift the T-Arm straight UP and out
of the T-Arm socket.
7. Repeat STEPS 3-6, if necessary until the T-Arm slides in the T-Arm
socket as desired.
8. If necessary, install rear wheels. Refer to Installing/Removing Rear
Wheels on page 116.
FIGURE5 Adjusting T-Arm Sockets.

Perform this procedure if the T-Arm is too loose in the socket or does not easily slide UP and DOWN in the socket.

The T-Arm socket will disassemble if the four hex
screws and washers are removed
.
T-Arm
Hex Screws and
Washers
T-Arm Socket
T-Arm Clamp
Locking Lever
Slot
Hex Screws
and Washers