Invacare Solara 3G - Securing the Occupant

5 TRANSPORT READY OPTION
Part No 1154295 63 Invacare® Solara®3G/Spree 3G Wheelchair
5.5 Securing the Occupant
Wheelchair-Anchored Belts
The wheelchair has been provided with a pelvic belt which meets the requirements of ANSI/RESNA WC/19.
The pelvic belt provided by Invacare has been designed to accommodate use on either side of the vehicle. If necessary, follow the instructions below
to reverse the orientation of the pelvic belt to accommodate the vehicle-anchored upper torso belt.
1. Install the pelvic belt pin (Detail “A” of FIGURE3) into slot in the pelvic belt bracket. Pull upwards until it snaps into place.
2. Repeat STEP 1 for the opposite pelvic belt bracket.
3. Install the vehicle-anchored upper torso belt onto the pin on the male end of the pelvic belt.

WARNING
The pelvic belt that is provided by Invacare has been tested for use in a motor vehicle on this wheelchair only. DO NOT
replace the pelvic belt with a different style pelvic belt.

Note the position of the male end of the belt when installing the pelvic belt onto the pelvic belt brackets. The male end of
the pelvic belt (Detail “A” of FIGURE3) has a pin which is used to secure the vehicle-anchored upper torso belt.