10
will display xx hour, with OFF blinking. In this case, press▲ or ▼ button to adjust timer on and then
press Timer to confirm. If Mode button is pressed before pressing Timer button to confirm, timer mode
will be switched to timer on setting mode. In this case, LCD displays xx hour, with ON blinking. In this
case, press▲ or ▼ button to adjust timer on and then press Timer button to confirm. When LCD
displays xx hour on off, xx hour means time of timer off, but time of timer on won’t be displayed.
Cancel timer: After setting of timer, if Timer button is pressed, LCD won’t display xx. Hour so
that timer setting is canceled.
Timer off setting under on-state of the unit is shown as Fig.11
Fig.11 Timer setting under on state of the unit
Timer range: 0.5-24hr. Every press of▲ or ▼ button will make setting time increased or
decreased by 0.5hr.If press either of them continuously, setting time will automatically increase/
decrease by 0.5hr every 0.5s.
Note:
1. If both timer on and timer off are set in unit on interface, the wired controller only display time of
time off. If both of them are set in unit off-state, only time of timer on is displayed.
2. Timer on in unit on-state is timed from the time of unit off and timer off in unit off-state is timed
from the time of unit on.