EasyManuals Logo

INVENTOR V1KI-09 User Manual

INVENTOR V1KI-09
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
16
5.12 Blow Function Setting
BLOW function: After the unit is turned off, water in evaporator of indoor unit will be
automatically evaporated to avoid mildew.
In cooling and dry mode, press Function button till the unit enters BLOW function, with BLOW
blinking, and then press Enter/cancel button to turn on this function.
In BLOW mode, press Function button till the unit enters BLOW function and then press
Enter/cancel button to cancel this function.
BLOW function setting is shown in Fig.17:
Fig.17 Blow function setting
Note:
1. After setting BLOW function, turn off the unit by pressing On/Off button on remote controller,
indoor fan will run at low fan speed for 10 min. (BLOW shows).Meanwhile, if BLOW function is
canceled indoor fan will be turned off directly.
2. There is not BLOW function in fan or heating mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INVENTOR V1KI-09 and is the answer not in the manual?

INVENTOR V1KI-09 Specifications

General IconGeneral
BrandINVENTOR
ModelV1KI-09
CategoryAir Conditioner
LanguageEnglish

Related product manuals