12
Note:
In air exchange mode, press Function button or there is not any operation within 5s after the last
button operation, the system will be quit from air exchange setting and current energy-saving data won’t
be memorized.
5.8 Sleep Setting
Sleep on: Press Function button under on-state of the unit into sleep function and then press
Enter/cancel button to turn on sleeping function.
Sleep off: During sleep on-state, press Function button to go to the sleep function and then press
Enter/cancel button to turn off this function.
Sleep setting is shown as Fig.13:
Fig.13 Sleep setting
Sleep setting is clear after power failure and then power recovery. There is not sleep function in fan
and auto mode.
Note:
In cooling and dry mode, if the unit with sleep function has run for 1 hour, the preset temperature
will be increased by 1°C and 1°C in another 1 hour. After that, the unit will run at this temperature. In
heating mode, if the unit with sleep function has run for 1 hour, the preset temperature will be decreased
by 1°C and 1°C in another 1 hour. After that, the unit will run at this temperature.
To Next Page
Loading...
Need help?
General
