INVT GD300L-1R5G-S2 User Manual

Goodrive300-LIFT series inverter Installation guide
-15-
Environment
Conditions
may occur.
Humidity
RH≤90%
No condensation is allowed.
The maximum relative humility should be equal to or less than 60% in
corrosive air.
Storage temperature
-30–+60˚C
Running environment
The inverter installation site should:
 keep away from the electromagnetic radiation source;
 keep away from contaminative air, such as corrosive gas, oil mist
and flammable gas;
 ensure foreign objects, such as metal power, dust, oil, water cannot
enter into the inverter (do not install the inverter on the flammable
materials such as wood);
 keep away from radioactive and flammable materials, direct
sunlight, contaminative liquids, salty and vibration environments.
Altitude
<1000m
When the altitude exceeds 1000m but is lower than 3000m, derate 1%
for every additional 100m;
When the altitude exceeds 2000m, configure an isolation transformer
on the input end of the inverter.
When the altitude exceeds 3000m but is lower than 5000m, contact
our company for technical consultation. Do not use the inverter at an
altitude higher than 5000m.
Pollution level
Level 2
Vibration
≤ 5.8m/s
2
(0.6g)
Installation direction
The inverter needs to be installed on an upright position to ensure
good cooling conditions.
Note:
• GD300L series inverters should be installed in a clean and ventilated environment according to
enclosure classification.
• Cooling air must be clean, free from corrosive materials and electrically conductive dust.
4.2.2 Installation direction
The inverter may be installed on the wall or in a cabinet.
The inverter must be installed in an upright position. Check the installation direction according to the
requirements below. Refer to Appendix C "Dimension drawings" for frame details.

INVT GD300L-1R5G-S2 Specifications

General

Brand	INVT
Model	GD300L-1R5G-S2
Category	Inverter
Language	English