INVT SPC Series User Manual

SPC Series Solar Pump Inverter Installation guidelines
-9-
Environment
Condition
has been idled for a long time, install an external heating device
before the use to eliminate the freeze inside the inverter. Otherwise,
the inverter may be damaged.
Relative
humidity (RH)
Less than 95%
Storage
temperature
-40°C–70°C, with the air temperature change rate less than 1°C/minute.
Running
environment
Install the inverter in a place:
 Away from electromagnetic radiation sources;
 Away from oil mist, corrosive gases, and combustible gases
 Without the chance for foreign objects such as metal powder, dust,
oil and water to fall into the inverter (do not install the inverter onto
combustible objects such as wood)
 Without radioactive substances and combustible objects;
 Without hazard gases and liquids;
 With low salt content
 Without direct sunlight
Ingress
protection
(IP) rating
IP65
Altitude
 When the altitude is higher than 2000m but lower than 3000m,
derate the inverter by 1% for every increase of 100m.
 When the altitude is higher than 3000m but lower than 5000m,
consult us for technical consulting. It is not recommended to use the
inverter when the altitude exceeds 5000m.
Installation
direction
Install the inverter vertically to ensure good heat dissipation performance.
Note:
 The inverter needs to be installed at a clean and ventilated environment according to
the housing IP rating.
 The cooling air must be clean enough and free from corrosive gases and conductive
dust.

INVT SPC Series Specifications

General

Brand	INVT
Model	SPC Series
Category	Inverter
Language	English