INVT SPC Series User Manual

SPC Series Solar Pump Inverter Function parameter list
-39-
Function
code
Name
Description
Default
Modify
1: Password protection is valid.
Hundreds place: User-defined
communication command address
0: Invalid
1: Valid
The hundreds place of P14.06 is used to
define whether a user-defined address is
valid. The value 0 indicates the standard
communication mode is used, while the
value 1 indicates a user-defined
communication address is supported. A
user-defined communication address
takes priority. Supported user-defined
addresses are P14.07 (Run command)
and P14.08 (Frequency giving). You can
set the address according to the type of
inverter that will be replaced.
P14.07
User-defined
address for
running
commands
0x0000–0xFFFF
0x1000
○
P14.08
User-defined
address for
frequency
setting
0x0000–0xFFFF
0x2000
○
P14.10
Enabling
upgrade
0: Disable
1: Enable
Only when this parameter is set to 1
(Enable), P14.01 is automatically
updated to 6, and the RMS module can
upgrade the firmware.
Note: Firmware upgrade requires that the
machine is not in running state.
0
◎
P14.11
Boot software
version
1.00–9.99
●

INVT SPC Series Specifications

General

Brand	INVT
Model	SPC Series
Category	Inverter
Language	English