www.ioncamera.com EN - 17
Recording in CAR Mode (Power on/off)
1. Slide the Mode Switch to the Car
position to set it to CAR mode.
2. Make sure a MicroSD card has been installed into the CAR slot. The memory
card is required to have at least 8GB free space. A 32GB or above card is
recommended for the car recording features.
Note: Please check your computer to make sure a card larger than 32GB can
be read.
3. Press and hold the PWR/REC/STOP
button until the LED lights up to turn
the camera on and start recording.
4. When connected to the car’s power supply, the camera will detect the
movement of your car to power on and start recording automatically.
Note: You can turn on the camera manually by pressing and holding
in
case it cannot be powered on automatically.
5. When the camera is not connected to any power supply or if you want to start
recording before driving, press and hold PWR/REC/STOP
to power on
and start recording.
6. The camera is always recording when ON in CAR mode.
7. A short vibration indicates recording has started. The LED indicator
illuminates in RED throughout the recording.
To Next Page
Loading...
Need help?
General
