www.ioncamera.com EN - 32
the latest firmware. The Blue LED illuminates to show that the firmware is
installing. The process will take approximately 20 seconds. Do not power off the
camera during this time as the power interruption can lead to potential camera
damage.
6. The Blue LED will turn off once the installation of the new firmware is
completed.
7. The camera will turn off when the upgrade is done. You can power on the
camera and the new firmware will be effective.
Place your camera on a stable position throughout the firmware update process.
Ensure that you do not reset the camera or remove the MicroSD card until the full
update process is completed. Any interruption, such as a sudden interruption of
power supply, will lead to potential damage to the camera due to firmware update
failure.
To Next Page
Loading...
Need help?
General
