FALCO Instrument User Manual V1.2R
Unrivalled Gas Detection. Page 39 of 46 ionscience.com
The power supplied to the MiniPID sensor is not dangerous to the user by either the risk of electrocution or
cause a threat of an explosion in a hazardous environment.
It is however good practice to remove local power to circuitry when servicing to avoid possible damage by
short circuit.
A service mode setting that removes local power is therefore available and can be switched to and from using
this screen.
The lamp symbol on the screen indicates whether or not the sensor service mode is on or off.
If the sensor is in normal mode is displayed.
If the sensor is in servicing mode is displayed.
If the instrument is in fixed output test mode is displayed.
If the instrument is in oscillating output test mode is displayed.
To change the setting, press the Up or Down key. The symbol will change as appropriate. Press the Up
or Down key again to reverse the setting.
Press the Enter key to save the setting change and return to the i1 menu.
Press the Esc key to return to the i1 menu without saving the change to the setting.
See below for how to change these settings.
The current password number will be displayed on the screen. The default value is 0000, which sets the lock to
“off”.
Change the password number as required. Use the same method for changing numbers as described
previously for the Alarm1 setting.
Changing the number to any number apart from 0000 will set the lock to “on”, with that number as the
required password.
Change the password number back to 0000 to turn the lock off again.
To Next Page
Loading...