IPCAM User Manual
24 / 67
3.5 For Administrator
When you login as administrator, “For Administrator” is enabled.
Device Info:You can find the information about Device ID,Firmware Version and
Embeded Web UI Version.
Figure3.7
Alias Settings: You can Input the new name as you like.
Data &Time Settings: Data &Time Settings page.
Users Settings: Eight accounts are acceptable for this system. Here the eight users can
configure their user names and password as Administrator, Operator or Visitor.
Visitor: In this mode, you can only view.
Operator: You can control the direction of IP Camera and set some parameter.
Administrator: You can setup the advanced configurations of the IP Camera.
UpnP Settings: If you access IP Camera, to be make sure UpnP Status is Succeed.
Upgrade Device Firmware: Upgrade Device Firmware and device embeded web UI
software in this page.
Restore Factory Settings: Restore factory settings of the device.
Reboot Device: Reboot the device.
Back: Back to Monitoring Mode.
3.5.1 Multi-Device Settings
Add cameras in LAN
In the Multi-Device Settings page, you can see all devices searched in LAN. The 1
st
Device is this device in default. You can add more cameras list in LAN for monitoring.
To Next Page
Loading...