iPECS eMG100 - Page 24

iPECS eMG80/100 & eMG800 & UCP
User Portal User Guide Issue 1.4
21
Attributes
Description
Range
Default
Call Wait
When a busy station receives a call, the call may queue to the
station instead of receiving busy tone. With Call Wait, the caller
hears Ring-back and the user sees the CO line button LED
flash. OFF, For External/Internal, For External, For Internal
Refer to
description
For
External/
Internal
Choice
Executive/Secr
etary Message
When a call forwards to the Secretary of an
Executive/Secretary pair, messages can be left for the
Executive (ON) or Secretary (OFF).
OFF,
ON
ON
Wake up Time
The user can register a Wake-up time and set the Wake-up
alarm to repeat on a daily basis. Wake-up alarm rings once if
the repeat is not checked. Available only system Attendant
New 5 Wake up usage is Off.
hhmm
(Must be 4
digits)
Headset or
Speaker Mode
The device, Speakerphone or Headset, to receive audio for a
call can be selected.
Speaker,
Headset
Speaker
Headset Ring
Mode
Ring for an incoming call can be delivered to the Headset,
Speaker or both the Headset and Speaker.
Speaker,
Headset
Headset
User Name
Registration
A name can be entered to display in the LCD of iPECS IP and
LDP Phones calling the station.
Max. 20
characters
BGM
From the portal, the user can select the source for Background
Music that is played over the iPECS IP or LDP phone speaker
while the station is idle.
No BGM, Internal/External Music 1, External Music 2,
VSF MOH, SLT MOH1~5, VSF MOH2~3
Refer to
description
No BGM
Station Ring
Type
The user may select one of eight ring signals for Intercom calls.
The station ring type may be different according to the type of
phones.
1-8
1
CO Ring Type
The user may select one of eight ring signals for incoming
outside calls. The CO ring type may be different according to
the type of phones.
1-8
1
SMTP Server
Address (IP or
Domain Name)
This field defines the address or URL of the SMTP mail server
for the notification.
IP v4 addressor Mail server name
Refer to
description
VSF MSG –
User Mail
Address
The system can send an E-mail to the user as notification of a
new Voice message in the user built-in Voice Mailbox. This
field defines the E-mail address to notify when a new message
is received.
E-mail
address
Station
Forward No
Answer Timer
This timer determines the duration the station will ring prior to
Ring-No-Answer Forward. This setting affects both manual and
Preset Call Forward and overrides the System No-answer
timer.
000-600
seconds
0
CLIR Service
CLIR (Calling Line Identification Restriction), a carrier service,
removes calling party ID sent from the ISDN to the called party
with a RESTRICT instruction in the SETUP message. If
enabled here, the system will send the RESTRICT instruction
to the PSTN when an outgoing ISDN call is placed.
OFF,
ON
OFF