| Safety
18
YLS-K
2 Safety
The product was designed, manufactured and tested for safety accord-
ing to the currently applicable safety rules and laws and current engi-
neering practices. The product is in a technically fault-free condition.
However, the product can pose dangers when it is
• operated by personnel without proper training.
• used improperly or contrary to the intended use.
• not in a fault-free condition from a safety perspective.
2.1 Safety instructions
Normal operation
Operation of the product is only permitted if all safety equipment is in
operation.
Secure access to the work zones using isolating protection equipment
with safety interlock function (laser cell) such that the area outside the
work zones satisfies the requirements of laser class 1.
The product housing must always be closed and locked during opera-
tion. Issue the housing key only to authorized personnel for mainte-
nance and repair work.
Maintenance
Maintenance work may only be performed by trained experts.
Never operate the product with faulty or non-operational electrical con-
nections.
Comply with the inspection and maintenance intervals specified by the
manufacturers for electrical and mechanical components.
Always perform cleaning and maintenance work on the product while it
is shut down. Always follow the procedure for decommissioning of the
product described in this operating manual. Immediately following
completion of the work, all safety features and protection equipment
must be reattached or put into operation.
Only permit authorized and appropriately trained personnel who have
received safety training to access the product. Always close the product
housing after maintenance work.
In the event of faults in the energy supply, switch off the product imme-
diately.
2.2 Intended use
The product is intended exclusively for material processing, in particu-
lar for cutting and welding applications on metals and metal alloys.
To Next Page
Loading...
