9
12: Test Home Base (if applicable)
Test returned Home Base with an *approved* power supply and robot
o Clean Home Base (electrical contacts and IR emitter)
o Check if power and dock LEDs are solid green when charging
o Visually inspect contact springs
o Perform Home Base mobility/docking tests
Appendix B
Appendix H
13: Test Virtual Wall & Light House (if applicable)
Test returned Virtual Wall with charged batteries
o Clean Virtual Wall (IR emitter)
o Check power light (if blinking then batteries are low)
o Perform Virtual Wall mobility tests
Appendix B
14: Test Wireless Command Center (if applicable)
Test Wireless Command Center with charged batteries
15: Replace Faulty Accessories
Replace faulty accessories
16: Pack & Record the Serial Numbers
Pack the robot. If a core robot exchange was necessary, record the new serial
number in the service process report
17: Monthly Data Report to iRobot
The detailed International Service Process Report should be managed monthly and
sent Tonia Giesecke at tgiesecke@irobot.com or Martijn Braam at
mbraam@irobot.com).
To Next Page
Loading...
