26
7. Press the / buttons to adjust the month setting.
JA - January Fe - February MR - March
AP - April My - May, JN - June,
JL - July AU - August SE - September,
OC - October nO - November DE - December.
8. Press the Manual button (one time) to select the Day setting.
9. Press the / buttons to select the current calendar day.
Example: September 17th would be displayed as S:17.
10. Press the Manual button (one time) to select the Year setting.
11. Press the / buttons to select the year (09 = 2009).
12. When finished, return the Dial to the Current Time position.
13. Repeat steps 2–10 for each Program as needed.
14. Return the Function switch to the Run position.
Note: When an Odd/Even schedule is used, confirm that the current
day of the week is correctly set by turning the Dial to the Today
position. If the day of the week is incorrect, adjust the month, day
and year settings to properly synchronize the controller.
Also note that when using an Odd/Even schedule, watering never
occurs on the 31st of any month or February 29th of a leap year.
Day Exclusion Feature
When using a Skip Days and Odd/Even date watering schedule, watering
will not occur on the same days from week to week. To restrict watering
on specific weekdays; e.g., for scheduled mowing or maintenance, use the
Day Exclusion feature as follows:
1. Place the Function switch in the Set Programs position.
2. Select Program A, B or C.
3. Turn the Dial to the Day to be excluded.
4. Press the button display OFF.
5. Repeat steps 3 and 4 to exclude additional days.
6. When finished, return the Dial to the Current Time position.
7. Return the Function switch to the Run position.
This completes the basic programming requirements for automatic
operation.
To Next Page
Loading...
