2
SETUP PROCEDURES
CAUTION!
Before attempting to mount the master board, turn off the main power of the AC-
3000 and unplug
its
power cord.
Note that the cover of the operation panel must be removed before performing
the installation. (For removal procedure see the AC-3000lAC-3000E Service man-
ual.
Procedure
Attach both guide rails to the two AC-3000 board brackets.
Slide the master board into the guide rails, then affix the master board to the
AC-3000 board brackets using the M3 screw
(L=
10) and the collar.
Connect the harness to the master board
J3
(7 pin) connector and the AC-3000
main board (P-834) J6
(7
pin) connector.
Connect the DSUB (25p) harness to the master board
I1
connector, then attach
the DSUB (25p) (female) to the connector bracket.
N
0
TES:
Refer to the AC-3000 Service manual for detailed instructions on main body as-
sembly and disassembly.
After installing the master board, please set on the master board battery switch
to
ON.
AC-3000 SYSTEM
SETUP
REV0
To Next Page
Loading...
